Fan Assembly. Pgs - Craftmade Forza FZA52BNK5C1 Guia De Instalacion

5. Fan Assembly
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod.
diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
Determine the length of threaded downrod you
wish to use. Thread safety cable and electrical
wires through threaded end of downrod and pull
extra wire slack from the upper end of the
downrod. [Refer to diagram 2.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Slide yoke cover and canopy over downrod.
to diagram 3.]
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten set
screw securely. [Refer to diagram 4.]
WARNING: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
[Refer to
[Refer to diagram 2.]
[Refer
set screw
diagram 1
electrical wiring
downrod
clip
diagram 2
canopy
yoke cover
diagram 3
stop pin
diagram 4
page 4
stop pin
hanging ball
safety cable
yoke set screw
and nut
pin
downrod
motor
housing
set screw hole
hanging
ball