SICHERHEITSHINWEISE
INSTRUCTIONS DE SÉCURITÉ
ISTRUZIONI DI SICUREZZA
INSTRUCCIONES DE SEGURIDAD
SAFETY INSTRUCTIONS
General safety instructions
It is imperative the following safety and assembly instructions are followed as a safety measure.
The weights stated in the assembly instructions must not be exceeded under any circumstances.
■ ■
The surface on which the workstations are positioned must have adequate load-bearing capacity.
■ ■
On positioning the workstations, pay attention to corridors and safety distances in relation to machinery
■ ■
and installations. Corridors must not be encroached upon.
On working at the workstations, make sure that tools and workpieces cannot fall off the tabletop.
■ ■
On moving workstations, there must not be any objects on the tabletop, workpieces could fall and
■ ■
cause accidents.
Workstations must always be levelled such that tools and workpieces cannot fall off the tabletop.
■ ■
The controller is not allowed to be opened under any circumstances! There is a risk of electric shock.
■ ■
Modifications or changes to the controller, the cable remote control for the motor or any of the
■ ■
connecting cables are forbidden!
Electrical cables must not be subjected to a crushing hazard, bending or tensile load.
■ ■
During installation, it must be ensured that the components have acclimatised adequately to the
■ ■
ambient temperature.
Only use the connecting cables for the specific country.
■ ■
If the cables are damaged, unplug from the mains and have replaced by an appropriately qualified
■ ■
person.
Installation of the machine only by an appropriately qualified person. The mains system must be
■ ■
adequately protected using a residual current device (RCD).
Fasten cable appropriately to prevent tripping due to cables lying on the floor.
■ ■
6
www.lista.com