Cleaning
We recommend that you clean
your shaver with the turbo mode
for "sonic" vibration cleaning
when the faucet symbol
appears on the LCD panel.
1. Disconnect the power cord
. Apply some hand soap and
3. Slide the switch lock button
. Press the OFF/ON switch for
7
5. Remove the outer foil section
6. Wipe off any drops of water
from the shaver.
some water to the outer foil.
downwards to unlock the OFF/
ON switch.
more than seconds to
activate the turbo mode for
"sonic" vibration cleaning.
•
appears on the LCD
panel.
•
After about 0 seconds, it
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.
and press the OFF/ON switch
for more than seconds to
activate the turbo mode for
"sonic" vibration cleaning and
clean it with running water.
with a dry cloth.
Caution for turbo mode
•
Shaving in turbo mode may damage your skin. Turn the shaver
off and then on again to cancel turbo mode.
•
Do not place your fingers on the OFF/ON switch while using
the shaver. This may cause the shaver to turn off or enter turbo
mode.
Lubrication
To maintain shaving comfort for a long time, it is recommended
that the oil provided with the shaver is used.
1. Switch off the shaver.
. Apply one drop of oil to each of the outer foils.
3. Raise the trimmer and apply a drop of oil.
. Switch the shaver on, and run it for approximately five
seconds.
5. Switch off the shaver, and wipe off any excess oil from the
outer foils with a soft cloth.
7. Dry the outer foil section and
the shaver completely.
8. Attach the outer foil section to
the shaver.
9. Lubricate the shaver.
5