Preparation Of The Log Splitter; Work Area; Operation Of The Log Splitter - Macpower SF-7 Manual De Instrucciones

Caution:

Preparation of the Log Splitter

Both ends of the log should be cut as square to help prevent the log from riding out of the splitter during
operation. Do not split logs greater than 20 inches in length.

Work Area

NEVER operate the log splitter on slippery, wet, muddy or icy ground.
ONLY operate your log splitter on a level surface. Operating on a slope could cause the log splitter to roll
over or cause logs to fall
NEVER operate your log splitter in a damp or rainy environment to avoid electric shock or short circuit.
ALWAYS block the wheels to prevent movement of the log splitter while in
stand of log splitter, use bolt to mount the stand on the working table.
ONLY operate your log splitter in daylight or under good artificial light.
ALWAYS keep the work area clean. Remove split wood around your log splitter immediately to avoid
stumbling over it.

Operation of the Log Splitter

ALWAYS ensure the motor is properly grounded or apply protection device. Only use rubber-jacketed cable
of sufficient lead cross section as an extension cable.
KNOW how to stop the log splitter and disengage the controls before operating it.
NEVER place hands, feet or any body part between the ram and splitting wedge during forward or reverse
stroke. Serious injury or death could result.
NEVER straddle or step over the log splitter during operation.
NEVER reach or bend over the log splitter to pick up a log.
NEVER try to split two logs on top of each other.
NEVER try to cross split a second log.
Page 4
Do not touch rotating parts.
off. It is suggested to mount the log splitter on a 60-75cm height working table.
Always disconnect power supply
before performing maintenance,
cleaning, adjustments or moving
the log splitter.
operation. There are holes on the