Transportation - Macpower SF-7 Manual De Instrucciones

NEVER allow one person to operate while another is positioning the log.
NEVER attempt to load your log splitter when the ram is in motion.
ALWAYS use your hand to operate the control lever and the switch. NEVER use your foot, a rope or any
extension device.
NEVER move the log splitter while the motor is running. Shut off the motor when the log splitter is
unattended.
NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.
ALWAYS unplug the power cable before performing any maintenance and repair. Periodically check that all
nuts, bolts, screws, and belts are tightened properly.
NEVER alter your log splitter in any manner such as adding a rope or extension to the control lever or
adding to the width or height of the wedge. Such alterations may cause your log splitter to be unsafe and will
void the warranty.
ALWAYS perform all recommended maintenance procedures before using your log splitter. Replace all
damaged and/or worn parts immediately.
NEVER tamper with the motor to run it at excessive speeds. The maximum motor speed is preset by the
manufacturer and is within safety limits.
FIRE PREVENTION
ALL replacement parts must meet manufacturer's specifications.
NEVER operate your log splitter near a flame or spark. Hydraulic oil is flammable and can explode.
ALWAYS take a Class B fire extinguisher with you when operating this log splitter in dry areas as a
precautionary measure against possible flying sparks.

Transportation

NEVER move this log splitter while the motor is running.
NEVER carry any cargo or wood on your log splitter.
NEVER allow anyone to sit or ride on your log splitter.
Be careful when moving your log splitter on rugged and rough terrain. Keep your log splitter upright.
Page 5