Craftmade Riverfront RVF52 Guia De Instalacion página 6

5. Fan Assembly. (cont.)
With the hanging bracket secured to the
outlet box and able to support the fan, you
are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod
through opening in hanging bracket and let
hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up
with the hanging bracket tab.
WARNING: Failure to align slot in hanging
ball with tab in hanging bracket may result in
serious injury or death.
Tip: Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Find a secure attachment point (wood ceiling
joist highly recommended) and secure safety
cable. It will be necessary to use a heavy duty
wood screw, washer and lock washer (not
supplied) with the safety cable loop.
Replace vice on safety cable and adjust safety
cable length by loosening screw and nut on
the safety cable vice and pulling on the cable.
Adjust slack in cable to a hands length and
secure vice by tightening screw and nut
securely. [Refer to drawing at right.] The
loop at the end of the safety cable should just
fit over the threads on the wood screw. Test
safety cable by pulling on loose end of cable
with pliers. If the safety cable slips, the screw
and nut on the vice must be set tighter. Extra
cable slack can be left in ceiling area.
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be
understood that common sense and caution
are necessary factors in the installation and
operation of this fan.
wood
ceiling
joist
page 6
safety cable loop
wood screw
and washer
screw
nut
safety cable
hanging bracket tab
hanging ball slot
motor housing