Caracteristiques Techniques - Skil PWRCORE 12 Manual Original

- the battery is nearly empty (to
protect against deep discharge)
--> a low battery level or flashing low
battery level 8 b is shown by the
battery level indicator when pressing
button C; charge battery
! do not continue to press the
on/off switch after the tool is
switched off automatically;
battery may be damaged
• Operating the tool 9
- press switch A once to turn on the
light in high brightness mode
- press switch A again to select low
brightness mode
- press switch A again to turn off
the light
• Adjusting the lamp head q
- the lamp head B pivots 120 degrees
- manually move the head to any
position
! do not force the head beyond
120 degrees
• Holding and guiding the tool w
! hold the tool at the grey-coloured
grip area(s)
MAINTENANCE / SERVICE
• This tool is not intended for
professional use
• The light source of this tool cannot be
replaced (if the LED-light reaches the
end of its service life, the tool must be
discarded)
• Always keep the tool clean
! remove battery from tool before
cleaning
• If the tool should fail despite the care
taken in manufacturing and testing
procedures, repair should be carried
out by an after-sales service centre for
SKIL power tools
- send the tool undismantled
together with proof of purchase to
your dealer or the nearest SKIL
service station (addresses as well
as the service diagram of the tool
are listed on www.skil.com)
• Be aware that damage due to overload
or improper handling of the tool will
be excluded from the warranty (for
the SKIL warranty conditions see
www.skil.com or ask your dealer)
ENVIRONMENT
• Do not dispose of electric
tools, batteries, accessories
and packaging together with
household waste material (only for
EU countries)
- in observance of European Directive
2012/19/EC on waste of electric
and electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned
to an environmentally compatible
recycling facility
- symbol 6 will remind you of this
when the need for disposing occurs
! prior to disposal protect battery
terminals with heavy tape to
prevent short-circuit
b
Lampe LED sans fil
INTRODUCTION
• La baladeuse a été conçue pour
éclairer dans des locaux secs
• Cet outil n'est pas conçu pour un
usage professionnel
• Lisez attentivement ce manuel
d'instruction avant d'utiliser l'outil et
conservez-le pour pouvoir vous y
référer ultérieurement 3
CARACTERISTIQUES
TECHNIQUES 1
Dimensions (longueur x largeur x
hauteur): 110 x 63 x 180 mm
ELEMENTS DE L'OUTIL 2
A Interrupteur marche/arrêt
B Tête de lampe
C Indicateur de niveau de
charge de la batterie
SECURITE
GENERALITES
• Faites attention en utilisant la
baladeuse
6
2155