Fitting The Gearmotor To The Guide; Mounting The Gearmotor To The Ceiling - King gates ELEVO Serie Instrucciones Y Advertencias Para La Instalación Y El Uso

3.2.3 - FITTING THE GEARMOTOR TO
THE GUIDE
Fit the ELEVO gearmotor output shaft to the guide head [A] and
secure using 4 M6.3x38 screws [G] (fig. 14). The gear motor
rotates and can be positioned in three different ways (fig. 3).
FIG. 14
3.2.4 - MOUNTING THE GEARMOTOR
TO THE CEILING
1. On the basis of distances A, B and C in fig. 2 and 3, trace the
two fixing points of the front guide bracket at the centre of
the door.
On the basis of the type of support surface, the front bracket
can be fixed with rivets, plugs or screws (fig. 15). If distances
A, B and C (fig. 2 and 3) are sufficient, the bracket can be
fixed directly onto the ceiling.
FIG. 15
2. After drilling the holes in the relative points, leaving the
gearmotor on the ground, lift the guide from the front section
and secure using two screws, plugs or rivets, according to the
installation surface.
3. Secure the brackets [H] using the screws [I] and nuts [L],
selecting the hole most suited to ensure distance B, as shown
in ( fig. 16)
FIG. 16
4. Using a ladder, lift the gearmotor until the brackets are
touching the ceiling. Trace the drilling points and then return
the gearmotor to the ground.
5. Drill at the outlined points and then, using a ladder, lift the
gearmotor until the brackets are placed against the drilled
holes (fig. 17) and secure using screws and plugs suited to the
support surface (fig. 18).
FIG. 17
FIG. 18
- 31 - - 31 -