Armada Technologies Pro900 Guía De Uso página 4

Armada Technologies Pro900™ LOCATOR USER GUIDE
into the "12 V" external power receptacle on the transmitter panel
and
the traditional bladed end into a wall outlet. The transmitter is then
powered by AC mains voltage instead of batteries.
The Pro900™ transmitter also can use 8 "D" (LR20) alkaline batteries
that are installed inside the transmitter battery compartment. Remove
the battery compartment cover and install the batteries, paying particular
attention to the positive and negative poles.
A 9-volt square (6LR61) alkaline or lithium battery is needed for the
Pro900™ receiver. It is important that the 9V battery is either alkaline or
lithium. Do not use a zinc carbon 9V battery. To install this battery,
remove the battery compartment cover located on the back top portion
of the Pro900™ receiver with a flat-head screwdriver. Install the 9 volt
battery by connecting it to the battery snap boot inside the battery
compartment. Don't yank or pull hard on the battery boot. Finally,
replace the battery cover.
To test that the batteries have been correctly installed, turn each unit on.
The control panel LCDs will come on if the batteries have been
connected correctly. If not, repeat the installation procedures. The
battery compartment is designed to hold the batteries tightly so if you do
not get a signal for power, try adjusting the batteries by rolling them or
moving them forward and backward until the power does come on.
Battery Condition Indicators -
There are low
battery indicator symbols on the left edge of both the
transmitter and receiver display panels. These "fuel
gauge" battery symbols will be solid when fresh and
diminish to empty as the batteries are depleted.
4