Complete The Installation - Kohler STERLING 7614 Serie Guia De Instalacion

13. Complete the Installation

CAUTION: Risk of property damage. Make sure a watertight seal exists around the drain and
overflow.
Connect the drain to the trap according to the drain manufacturer's instructions.
Install the faucet trim, shower door, and any accessories according to each manufacturer's
instructions.
Remove the protective covering from the whirlpool.
Open the water supply lines, then run the water to flush out any debris.
Close the valve.
Install the showerhead according to the manufacturer's instructions.
Check all connections for leaks.
CAUTION: Risk of property damage. If holes have been or must be drilled to properly install
your accessory, we recommend applying 100% silicone sealant into the drilled holes before securing
the accessory to the wall surround to avoid possible water damage. Follow the accessory
manufacturer's instructions.
If applicable, apply 100% silicone sealant into the previously drilled holes in the wall surround.
Refer to the accessory manufacturer's instructions to properly secure the accessory to the wall
surround.
If applicable, install all other accessories according to the manufacturer's instructions.
If a shower door will be installed, refer to the shower door manufacturer's instructions to complete
the shower door installation. Only apply silicone sealant where instructed to do so.
If a shower curtain will be used, ensure the rod is installed above the wall surrounds.
1070292-2-J 18 Sterling