Troubleshooting - Kohler STERLING 7614 Serie Guia De Instalacion

15. Install the Apron Access Panel
IMPORTANT! Risk of product damage. Ensure that the tabs are aligned before pressing the apron panel
into place. Improper alignment can damage the clips.
Ensure that the apron area is free from obstructions.
Align the center clip of the access panel with the center slot of the apron frame.
Press the center clip until the apron panel snaps into place.
Slide the apron panel up under the apron frame until the two top clips engage and the apron panel
aligns with the remaining clip positions.
When positioned, press on each of the remaining clip locations to engage the snap-in clips.

Troubleshooting

This troubleshooting guide is for general aid only. An Authorized Service Representative or qualified
electrician should correct all electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms
1. Whirlpool does not
start/stop.
2. Motor starts, but all jets
are not functioning.
Whirlpool stops
3.
automatically.
4. Noisy operation.
5. Leakage is detected under
the whirlpool.
1070292-2-J
Apron Frame
Apron Panel
Probable Causes
A. No power to the pump motor.
B. Air actuator does not work.
C. Motor/pump does not work.
A. Jet is closed.
B. Jet is blocked.
A. GFCI trips.
B. Suction blocked.
C. Jets are blocked.
D. Motor overheated and
protection device activated.
A. Pump banding straps have not
been cut.
A. Piping leaks.
Tabs
Clips
Recommended Action
A. Set/Reset the GFCI breaker. Check
the wiring.
B. Replace air actuator. Check air tube
between air actuator and pump.
Replace if necessary.
C. Rebuild or replace motor/pump.
A. Rotate jet trim ring
counterclockwise to open.
B. Remove the blockage.
A. Identify source of fault, and correct.
B. Remove obstruction.
C. Remove blockage.
D. Check for blockage at motor vents.
Remove blockage and allow motor
to cool.
A. Cut pump banding straps with a
pair of tin snips.
A. Repair any piping leaks.
20 Sterling