Troubleshooting - Champion Essick WC37 Manual

Problem Possible Cause
1. No electrical power to
Failure to
unit
start or no air
Fuse blown
delivery
Circuit breaker
tripped
Electric cord un-
plugged or damaged
2. Belt too loose or tight
3. Motor overheated
.
Belt too tight
.
Blower bearings dry
4. Motor locked
I. Insufficient air exhaust
Inadequate
air delivery
with cooler
2. Belt too loose
running
3. Pads plugged
I. Inadequate exhaust in
Inadequate
cooling house
2. Pads not wet
Pads plugged
Open spots in pads
Trough holes
clogged
Pump not working
properly
Register your product online at
This walTanty is extended to the original purchaser of an evaporative cooler installed and used under nonnal conditions.
through accident, neglect, or abuse by the owner. We do not authorizc any person or representative
,
nection with this product.
Terms And Conditions Of The Warranty
For Eight Years from date of purchase, we will replace the original base assembly if water leakage should occur due to rust out.
For One Year from date of purchase, we will replace any original component provided by Champion Cooler which fails due to any defect in material or fac~
tory workmanship only.
Exclnsions From The Warranty
We arc not responsible for replacement of cooler pads. These arc disposable component,> and should be replaced periodically.
incidental or consequential damage resulting from any malfunction.
We arc not responsible for any damage received from the use of water softeners, chemicals, descale material, plastic wrap, or if a motor ofa higher horsepower
than what is shown the serial plate is used in the unit.
Oll
We arc not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.
For limiled warranty to be valid the evaporative cooler must be maintained per the Maintenance Section of this manual.
How To Obtain Service Under This Warranty
Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response from the dealer, contact the Customer
Service Department: 5800 Murray Street, Little Rock, Arkansas 72209.
This IimUed warranty applies to the original purchaser only.
110496-1

Troubleshooting

Remedy
I. Check power
Replace fuse
Resel breaker
Plug in cords or
if
replace damaged
2. Adjust belt tension
3. Detennine cause of
.
overheating
Adjust belt tension
Oil blower bearings
4. Replace motor
I. Open windows or
doors to increase air
flow
2. Adjust belt tension or
replace if needed
J
Replace pads
I. Open windows or
doors to increase air
!low
2. Check water distribu-
tlon system
Replace pads
Repack pads
Clean trough and
unplug holes
Replace or clean
pump (Unplug
unit)
www.championcooler.comli ••dex.phplcooler~lVarranty-registration
Limited Warranty
Problem Possible Cause
I. Low voltage
Motor cycles
on and ofT 2. Excessive belt tcnsion
3. Blower shaft tight or
locked
4. Bearings dry
Noisy 1. Bearings dry
2.
Wheel rubbing blower
housing
3. Loose parts
Excessive 1. Inadequate exhaust
humidity in
house
I. Stale or stagnate water
Musty or
unpleasant in cooler
2. Pads mildewed or
odor
clogged
J
Pads not wetting
properly
Trough holes
clogged
Pump not working
properly
Water drain- I. Float
ing from properly
cooler 2. Overflowasscmbly
leaking
to assumc for us any other or different liability in con-
1.800~643.8341. Email: info@championcooler.com.
Remedy
I. Check voltage
2. Adjust belt tension
3. Oil or replace bear-
iogs (Unplug unit)
4. Oil bearings
1. Oil bearings
Inspect and realign
2.
(Unplug unit)
3. Tighten loose parts
1. Open doors or win~
dows
I. Drain pan and clean
pads
2. Replace pads
3.
Check water distribu-
tion system
Clean
Replace or clean
pump (Unplug
unit)
not adjusted I. Adjust float
31m
2. Tighten nut and
overflow pipe.
It does not cover damages incurred
We are not responsible for any
5