Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
48
AIR FILTER
Remove the air filter cover and remove the dust. If it is dirty, remove it and carefully clean it with hot water and a
neutral detergent. If the filter is deformed or damaged, replace it with a new one.
ATTENTION: Working without a filter or with a damaged or deformed filter causes irregular wear
on the engine mechanism.
FUEL FILTER
When the engine is running on low fuel, check that the filter is completely covered with gasoline so that it does not
catch air, otherwise the engine may choke.
SPARK PLUG
Start-up and ignition failures are often caused by a contaminated spark plug. Check and clean the spark plug regularly
and replace it with another one when necessary.
ATTENTION: When removing the plug from the cover, be careful not to remove the lock from the
cover plug. Working with the motor without a lock may cause the motor to overheat.
ATTENTION: When fitting the spark plug, screw it in with your fingers first, then tighten the screws
using a special wrench. Overtightening will damage the cylinder and piston.
SILENCER
AFTER 100 HOURS OF USE
•
Remove the muffler, insert a screwdriver into the vent and release any carbon buildup. Also remove any carbon
buildup from the muffler duct.
•
Tighten all bolts, screws and nuts.
•
Examine it to see if any grease has gotten between the clutch lining and the drum. In that case, dry it using oil-
free gasoline and lead.
TRANSPORTATION
•
Never transport the machine while the engine is running.
•
Wait 5 minutes after turning off the engine before transporting the machine.
•
If you are transporting the machine in a vehicle, secure it securely to prevent it from slipping or tipping over and
with the guard on the cutting elements.
•
Never transport the hedge trimmer on poor roads without first removing all fuel from the tank.
Publicidad
Capítulos
Tabla de contenido
