Metabo HPT C 1807DA Manual De Instrucciones Y Seguridad página 21

When
Inclined 45°
(2) When the base is not inclined, use the right side of the
notch (Fig. 28, Fig. 29).
If the base is inclined (45 degrees), use the left side of
the notch (Fig. 28, Fig. 30).
When not
Inclined
Fig. 28
Fig. 29
NOTE
When using the saw at the inclination of 45 degrees,
use both the marks of on the bevel plate and [45] on
the inclined gauge of the base (Fig. 31).
What's more, if it is absolutely essential to use the
saw at a precise angle, make adjustment using a
protractor, etc.
Incline lever
(3) Ensure that the switch is turned to the ON position
before the saw blade comes in contact with the
lumber. The switch is turned ON when the switch
trigger is squeezed; and OFF when the switch trigger
is released. Moving the saw straight at a constant
speed will produce optimum cutting.
English
Cutting line
(at 45 degrees)
Fig. 30
Bevel plate
Inclined gauge
Fig. 31
21