Metabo HPT C 1807DA Manual De Instrucciones Y Seguridad página 22

English
CAUTION
● Before starting to saw, ensure that the saw blade
has reached full speed revolution.
● When fi nished with a job, pull out the battery
from the main body.
● To avoid abnormal heating of the blade tip or
damage to the saw blade, do not twist or apply
excessive force to the saw blade when cutting.
Let the blade move forward smoothly.
● In the situation where the circular saw is
continuously operated while replacing the
battery with stocked spare batteries one after
another, the motor tends to overheat. Therefore,
whenever the housing becomes hot, give the saw
a break for a while.
● Avoid cutting operation in a state where the base
bottom is afl oat from the material being cut.
Otherwise, the motor can get locked.
[POCKET CUTTING]
WARNING:
● To avoid serious accident, ensure the switch is
OFF position, and disconnect the plug from the
receptacle before any adjustment.
● Never tie or wedge the lower guard in a raised
position.
1. Mark the desired cutting area clearly with lines all
side. (See Fig. 32)
2. Set depth adjustment according to material to be cut.
3. Push the lower guard lever all the way back so the
blade is exposed as shown in Fig. 32.
22
Lower
guard lever
Fig. 32
4. Tilt saw forward and align the notch (Fig. 28) with the
pre-marked guide line.
5. Release the lower guard lever. When the lower guard
contacts the work piece surface, it will be in proper
position to open freely when cutting is commenced.
6. Holding the saw in position, with the blade not
contacting the work piece surface, pull the trigger.
7. After the saw has reached full speed, gradually lower
rear end of the saw until its base rests on the work
surface.
8. Advance saw along the cutting line up to the corner.
9. Release trigger and allow blade to stop completely
before withdrawing the blade from the work piece.
○ Never under any circumstances pull the saw
backwards while the blade is in motion, as kickback
may result.
10. Use a jig saw or hand saw to cut the corners out clean.
11. When starting each new cut, repeat as above.