Craftsman CMXGZBF7124355 Manual De Instructiones página 8

ENglISh
Step 17: (fig. 17)
1. Turn cart over so that it rests right side up on its wheels.
2. Assemble the end of the hitch bracket (4) that has two
same size holes to the drawbar tongue using two 3/8"
x 1" (B) hex bolts and 3/8" nylock nuts (G). Tighten. See
figure 17.
3. Assemble the hitch pin (O) through the hitch bracket (4)
and the tongue and secure with the 1/8" hair cotter pin
(M). See figure 17.
Fig. 17
HITCH PIN (O)
3/8" x 1"
HEX BOLT (B)
3/8"
NYOCK
NUT (G)
OPerAtiOn

CAutIoN: to avoid possible injury, before
releasing the latch be sure that no one is near
the cart..

CAutIoN: Vehicle braking and stability may
be affected by the addition of an accessory or
attachment. Be aware of changing conditions on
slopes..
How to use Your cart
• Refer to the vehicle owners manual for instructions
about safe operation on slopes.
• For best handling and traction, distribute the weight of
the load evenly in the cart.
• Always test to make sure your tractor has adequate
towing and braking capabilities when hauling a
substantial amount of weight in your cart. Use extra
caution when operating on slopes
• To dump material from the cart, remove the tailgate by
lifting it straight up and out from between the guides.
Release the spring latch on the tongue by pulling the
latch lock lever forward, away from the cart. The cart
bed will then tilt backwards to empty its contents. After
emptying, pull the front of the bed down toward the
cart tongue until the latch snaps into place. Replace the
tailgate if desired.
• The maximum towing speed for this cart is 7 m.p.h.
• DO NOT EXCEED 750 LB. WEIGHT CAPACITY OF CART
• One cubic foot of dirt weighs approximately 80 lbs.
6
mAintenAnCe
check for loose fasteners
• Before each use make a thorough visual check of the
plug aerator for any bolts and nuts which may have
loosened. Retighten any loose bolts and nuts.
lubrication
• At the beginning of each season, lubricate, with a light
machine oil, the latch, the latch pivot bolt, and the area
of the axle where the draw bar tongue pivots.
• Grease or oil the wheel bearings periodically. Use
automotive wheel bearing type grease or 20 weight oil.
check tire Pressure
HITCH
• Keep tires filled to the recommended tire pressure
BRACKET (4)
printed on the tire.

1/8" HAIR
cleaning & Storage
COTTER
PIN (M)
• Clean dirt and debris off cart after each use.
• Store in a dry area. Cover exposed metal with a light
coat of oil
WARNING: over-inflated tires can explode,
causing serious injury. to avoid injury, NeVeR
inflate tires beyond the maximum pressure
printed on the sidewall of the tire. ALWAYS use a
hand pump to safely inflate tires..