Complete The Installation - Kohler Vanity K-2435 Manual De Instrucciones

Sealant location
Leveler

4. Complete the Installation

Secure the Vanity
Move the vanity against the finished wall in the desired position.
Ensure the vanity is level. If the vanity is not level, rotate the
leveler(s).
NOTE: Select the type of fastener based on the wall material. A
minimum of 50 lbs (22.68 kg) load bearing fastener is recommended.
Using fasteners, attach the vanity to the finished wall at the 2x6
material location.
Install the Vessel
CAUTION: Risk of product damage. Siliconized acrylic caulk must
be used to secure the vessel to the vanity. Do not use 100% silicone
sealant, which will damage the finish of the vanity.
IMPORTANT! If instructed to apply silicone sealant, use siliconized
acrylic caulk instead. Allow the caulk to cure for at least 30 minutes
before proceeding with the vanity installation.
Install the vessel according to the lavatory manufacturer's
instructions.
Connect the drain and supplies.
Kohler Co.
Finished Wall
Fastener
11
2x6 Material
1059700-2-B