Publicidad
Idiomas disponibles
Idiomas disponibles
NoticeEoh-4Trads-FRENESIT.qxp_Mise en page 1 04/03/2021 18:39 Page 19
F I R S T U S E
Remove the machine from its packaging and place it on a stable work surface, near to a
mains plug.
Remove the protective wrapping from the handle (carefully read the user precautions
printed on the wrapping.
Fit the pod basket (
7
), the strainer (
9
), and the strainer grid (
).
10
Rinse the water tank (
6
) and tank lid (
) with tap water.
5
Rinse the filter (
12
) with tap water.
Place the filter (
) in the water tank ( ), in the slot provided for this purpose (push right to
12
6
the back – see Filter replacement chapter on page 23).
Then:
1 - Fill the tank with fresh water ( ).
6
2 - Plug in the power cable (
13
).
2
3 - The central light (
) will display 3 colours (blue, white and red) one after the other,
and then go out. The machine is now on stand-by.
4 - Press coffee button ( ) or ( ) to start heating (both coffee buttons flash).
3
4
3
5 - When the machine reaches the required temperature, the two coffee buttons (
)
and ( ) will stay ON steady.
4
6 - Use the plastic dummy pod provided with your machine.
7 - Pull on the machine handle ( ) to maximum while lifting to reveal the pod slot.
1
8 - Insert the plastic pod in the slot and check positioning.
1
9 - Push the handle (
) towards the control buttons until completely closed.
You will need a container with a capacity of 0.5 l or more for the following operations.
Place this container under the machine coffee spout to catch the rinsing liquid.
10 - Press the Large Coffee button ( ). The light on the selected button will flash slowly
4
and the other button will go out. Initial rinsing will start. Rinsing will stop automatically
at the end of the cycle.
Repeat the operations twice to finalise rinsing.
11 - After the machine has been rinsed, raise the handle as far as possible (
1
) while pulling
towards you, the plastic pod will then fall into the used pod basket ( ). Pick up the plastic
7
pod, dispose of the liquid in the Pod Basket ( ), and dispose of the liquid in the container
7
used to catch the rinsing liquid. Refit the Pod Basket (
7
) en place.
After the machine has been rinsed, it can be used normally.
NOTE: If the machine is not used for more than 48 hours, we recommend repeating
steps 1 to 11 of this section.
18
Publicidad
