Winter Setting; Heating; Temperature Rise Phase; Maintaining The Temperature - BWT MY POOL Plug and Play Defrost Manual De Instrucciones

Winter setting

This appliance is made to be used during summer period only.
When you are winterizing your pool system, you must:
•
Turn the pool heat pump off
•
Close downstream and upstream valves of the by-pass system.
•
Drain the exchanger to prevent any risk of freezing.
•
Open completely the downstream and upstream valves to empty the heat exchanger tank before closing them.
•
Put the heat pump in a closed room protected against frost.

Heating

Temperature rise phase

As soon as you wish to re-start your swimming pool at the beginning of the season:
•
Proceed with all the usual initial operations (water filling, cleaning of the filter...,)
•
Turn the water pump on.
•
Turn pool heat pump on, set temperature.
•
Cover the pool with solar cover or other.
•
Leave the pool system and pool heat pump working permanently until the pool has reached the required
temperature (it will take approximately 36 hours to 1 week).
The time for the pool temperature to increase depends on the exposure of swimming pool to wind, sun and the pool
environment as well as the heat pump size.

Maintaining the temperature

Once the set temperature is reached, you may reduce the filtration period according to the temperature requirements
(12 hours a day minimum during the summer). The heat pump will re-start automatically when necessary.
The minimum working time depends of the season; contact your distributor for more information.
If the temperature decreases and the machine work every time the filtration pump is ON, increase the filtration time.
A thermal pool cover is very important in order to avoid unnecessary heat loss.
IMPORTANT: An uncovered pool will lose 4 times more heat than a covered pool.
The heat pump working is calculated for a covered swimming pool.
- 11 -