Operation In Automatic Mode; Entry Using Vehicle Code Number - Bosch ACS 400 Instrucciones E Manejo

ACS 400/450
10.

Operation in automatic mode

10.1

Entry using vehicle code number

i
Before starting the process, refer to section 9
"Preparation for A/C service"

Take code number from data manual for
ACS 400/450 (e . g . 03) .
LEDs
Display
R 134a
V
06:780
PrW-
WAU
PWW03
l7
inWoil
00:550
PWW03
-5WWA-
00:000
-5WWC-
-CWW0-
-5WWP-
l7:00
-999
-PWWA-
inWoil
inWoil
inWoil
inWoil
-PWWA-
00:000
00:000
00:550
06:230
Robert Bosch GmbH
Valve posi-
Signal
tion
Button
tone
R 134a LP
V
V
V
V
V
E
E
V (3 sec .)
V
HP
The filling weight of the internal coolant cylinder is displayed .
Set code number (e . g . 03) .

E
You can use to start the recovery/recycling phase immediately .
Vacuum time in min is displayed .
Oil injection phase active .
inWoil = Oil injection phase active .
noWoil = Oil injection phase deactivated .
Change setting with

Coolant quantity (kg) for filling the vehicle A/C system is displayed .
Start process .

Recovery/recycling phase begins .
Important! On vehicles with low pressure connection only, only
open LP valve .
Display increases until no more coolant is present in the vehicle A/
C system .
Collected coolant oil from the vehicle A/C system is transferred to
the waste oil reservoir . Waiting time 3 min .
Vacuum is generated in ACS 400/450 . Waiting time 1 min .
Display appears for approx . 3 sec .
Vacuum phase begins . Remaining time is displayed .
Pressure loss measurement (leak test) is performed . Waiting time
4 min .
Stoppage approx . 3 sec .
Oil injection phase is active .
Read off oil level in waste oil reservoir .

Add new coolant oil to fresh oil reservoir . Quantity corresponds to

oil level in waste oil reservoir .
Hold down button until all the coolant oil from the fresh oil reser-

voir has been added to the vehicle A/C system .
For vehicle A/C systems that are only fitted with a low pressure

connection, before filling is started the A/C system must be swit-
ched on in the vehicle, the A/C system temperature must be set to
its maximum and the fan must be set to its highest level .
Stoppage approx . 3 sec .
Filling phase is active . Display flashes for approx . 3 sec .
Vehicle A/C system is filled with coolant . Display increases until the
set filling weight (e . g . 00 .550 kg) is reached .
Filling phase complete . Display flashes .
Remaining quantity in internal coolant cylinder is displayed . Service
on vehicle A/C system is complete .
Comment
or .
1 689 979 930 (2005-09-23)
en