Xerox PHASER 3400 Guía Rápida De Instalación página 10

Software Setup - Macintosh Environment
1.
Install the Phaser 3400 printer driver on the Macintosh. Refer to the
Phaser 3400 Personal Laser Printer User Guide for instructions.
2.
Set the Control Panel:
a.
From the Apple menu, select the Control Panel.
b.
Select AppleTalk.
c.
In the AppleTalk window, in the Connect via drop-down
box, select Ethernet.
d.
Close the window and save the changes.
3.
Set up the Chooser:
a.
From the Apple menu, select the Chooser.
b.
Near the bottom of the Chooser, verify that AppleTalk is set
to Active.
c.
In the upper-left area of the Chooser, click LaserWriter 8.
d.
If the Macintosh computer and the Phaser 3400 printer are on
a wide-area network, you may see the AppleTalk Zones area
in the Chooser. Select the zone that has the Phaser 3400
printer.
If you don't know the zone, look up the Current Zone under
the AppleTalk Stack Details section on the printer's
Configuration Sheet. Refer to page 3 for instructions on
printing the Configuration Sheet.
If the zone name needs to be changed, use the Apple Printer
Utility.
e.
In the area of the Chooser under Select a PostScript Printer,
click Xer0000f0axxxxx (with x representing a hexadecimal
number). This is the default name of the Phaser 3400 printer.
f.
Click the Create button. The Chooser sets up the printer with
the Xerox Phaser 3400 printer's PostScript PPD file.
6
Phaser 3400 Personal Laser Printer