Replacing The Servo-Drive Switch Battery - blum HF-SD-01 Instrucciones De Montaje

Reset Motion
E
Reset Wireless
F
Cover cap assembly

Replacing the SERVO-DRIVE switch battery

When the battery power begins to weaken, the battery display (LED) begins to flash red
NOTE
➢ The SERVO-DRIVE switch battery must not be recharged or thrown into fire.
Resets the reference run and enables a new reference run to be
started.
Press the <Reset Motion> button using a pen (at least 3 seconds) until
the LED flashes quickly.
Deactivates all functions: All active SERVO-DRIVE switches for the
respective drive unit are deleted.
Press the <Reset Wireless> button using a pen (at least 3 seconds)
until the LED flashes quickly.
➢ Open the SERVO-DRIVE switch and
remove the battery
➢ Insert the new battery (type CR2032)
and close the SERVO-DRIVE switch –
note correct polarity +/-
EN
81