Publicidad
Casing for max. 3 pumps DOS-G2, Mat. no. 05 572 530
Essential for fitting the dispenser pump module DOS-P2 and includes parts for installing a
maximum of 3 dispenser pumps:
– Connection cables
– Individual connection wires, etc.
– Fastenings
(If the machine is already fitted with this module as well as with the module DOS-P2, Mat. no.
05 573 160, Points 8. to 8.4 do not apply and are not required.)
Stand for max. 3 pumps DOS-S, Mat. no. 04 814 240, (optional)
A module DOS-G2 casing for max. 3 pumps can be fitted on the module.
It includes:
– Stand complete
– Fastenings for the casing and the spray proofing pump
(If the machine is already fitted with this module, Points 9. to 9.3 do not apply and are not
required.)
Procedure:
^ 1. Disconnect the unit from the mains!
^ 2. Remove the machine lid.
^ 3. Depending on model version: Cut off and drill out (dia. 4.0 mm) the connections on the
dispenser box as appropriate. Use the bottom connections first (Fig. 1).
^ 4. Connect the liquid agent hose (dia. 6.0 mm) (1) to the drilled-out connection on the
dispenser box and secure it with a hose clip (2) (Fig. 1).
^ 5. With acidic agents, bleaching agents and similar chemicals a non-return valve (DOS-R,
Mat. no. 05 571 620) must be fitted in the intake upstream of the liquid detergent dispenser
box. For this the hose must be cut next to the dispenser box. Both hose ends must then be
inserted in the non-return valve and the screw fittings tightened firmly.
Care must be taken to check the direction of flow (2) (Fig. 2).
^ 6. Fit the holding plate (3) to the liquid dispenser box (Fig 2).
For this remove the screws (4) from the dispenser box, place the holding plate in position
and replace the screws (Fig. 2).
^ 7. Secure the hoses to the holding plate using cable ties (5) (Fig. 2).
8. Dispenser pump fitting in pump casing
^ 8.1 Fit a screw connection PG 13.5 in the casing bottom and secure it with a counter nut
(Fig. 3, Pos. 8 and 9).
Fit screw connections PG 9 as appropriate for the pumps to be fitted (Fig. 3, Pos. 1 - 7).
Close the remaining openings with stoppers and counter nuts.
10
M.-Nr. 05 648 960/01
Publicidad
