Child Safety Lock - MiLECTRIC RF-360 Manual De Usuario

TEMPERATURE CONTROL
1. Display on for 3 seconds with a long buzz when the product is connected with electricity.
2. A short buzz will be activated everytime pressing the button effectively.
3. There are 4 inductive buttons on the display:
- Temperature Up +
- Temperature Down -
- Fast Cooling

- Child Safety Lock

4. Key Function
4.1 Child Safety Lock
Press 3 seconds to activate/deactivate child safety mode.
Prompt invalid operation when pressing any button after entering child safety mode(digit flashing rapidly in display)
4.2 Temp up + & Temp down -
Adjusting inside temperature from 2 degree to 8 degree(cyclic adjustment not allowed)
Temperature setting without any further operation after 5 seconds(digit flash stop)
4.3 Fast Cooling
Under temperature setting mode, press Fast Cooling button to enter fast cooling mode.
Display shows "FC", working time for fast cooling is 3 hours.
After 3 hours, fast cooling mode automatically exits, temperature returns to the setting value before fast cooling mode.
5. Power failure Memory
Product remembers the following settings in case of power failure:
compressor running time and setting temperature
6. Door Alarm
If door open lasts more than 2 minutes, the buzzer starts to alarm, and it will alarm every 1 minute backward
(3 rings every 1 minute within 10 minutes), and the buzzer will stop alarming after 10 minutes.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow the refrigeration system pressures to
equalise before restarting.
• Turn off the appliance and unplug it from the mains socket. Remove all food.
• Relocate and install. If the appliance has been left on its side for any length of time, leave it standing upright for at least 10 minutes before
turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly and natural gas, it is explosive. Therefore
you should be careful during shipment and installation to prevent your appliance's cooler elements from being damaged. In the event of a leak
caused by damage to the cooler elements, move your fridge from open flame or heat sources and ventilate the room where the appliance is
located for a few minutes.
Digit Display
Temperature Up +
Temperature Down -
Fast Cooling
Child Safety Lock