MiLECTRIC RF-360 Manual De Usuario página 35

DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised service agent to make this
conversion or ask a technician.
Before you reverse the door, you should ensure the appliance is unplugged and empty. It is recommended to use a crosshead
screwdriver and a spanner (both not supplied).
Remove the right upper hinge cover and upper
hinge hole plug.
1

Remove the cylindrical light switch fixed on
the right upper hinge cover.
Remove the right upper hinge and door cover
hole plug.

Open the door cover hole plug, put the
2
wiring harness terminal of the door into the
door cover slot, and close the door cover hole
plug.
Lift the door upwards to disengage it from the
3
middle hinge, put the door to one side and lay it
down gently on a padded surface.
4
Remove left feet and right lower hinge.

Unscrew feet
Remove the hinge shaft

5
hole and insert it into the left hole. Tighten
the nut and then tighten the feet.

and then unscrew nut

from the right
.