Installation Instructions - Whirlpool GHWT160JXX2 Instrucciones De Instalación

off
position
quick-
connect
fitting
Numbers
correspond
to steps.
NOTE: Do NOT plug power supply cord into outlet.
1.
Put on gloves and safety glasses.
2-1/4" 2.
(5.7 cm)
Position tank vertically beneath
faucet so that flexible tubing from
faucet reaches center stainless
tubing on tank, and tank touches
wall. Use a pencil to mark on the wall
bracket where the top of tank needs to be
located. Set tank aside. Mark a
second line 2-1/4" (5.7 cm) below the
first line.
NOTE: Do NOT plug power supply cord into outlet.
3.
Connect 1/4" (6.4 mm) faucet
tubing to the rear quick-connect fitting
on top of tank. Push tubing straight
into fitting as far as it will go. Pull on
tubing. The tubing should not come
out when properly installed.

Installation Instructions

Faucet
shown for
reference
only.
5.
7.
NOTE: The tank must be
positioned so that the flexible
tubing to the faucet does not kink.
Position mounting bracket on wall so
that bottom of mounting bracket is
even with the lower line. Use two
screws (and plastic anchors if
attaching to dry wall) to fasten
mounting bracket to wall. Hang tank
on bracket.
Do Not lengthen, twist or tightly
bend tubing.
6.
flexible
tubing
3.
4.
2.
off
position
5