Whirlpool GHWT160JXX2 Instrucciones De Instalación página 6

clamp
flexible
tubing
6
Installation Instructions cont.
4.
Connect flexible tubing from
faucet to center tank tubing using
clamp. Make sure flexible tubing
does not kink.
The flexible tubing may be shortened
if necessary.
NOTE: Do NOT plug power supply cord into outlet.
5.
Turn Temperature Control
counterclockwise to "Off" position.
6.
Actuate faucet to fill tank. When
tank is full, water will flow from
faucet.
NOTE: Turn Temperature Control to
"Off" position before plugging hot
water tank into power supply. If
tank is empty and thermostat is in
an "On" position when the power
7.
Plug power supply cord into
grounded outlet.
Turn Temperature Control clockwise
to highest position.
Water in tank will reach maximum
temperature in approximately
15 minutes.
When water is heating, you may hear
gurgling noises coming from the tank.
There may also be some spitting or
supply cord is connected, the
heater will overheat causing an
unpleasant taste, black specks
in the water, and permanent
damage to the heater seals.
hot water flow from the faucet. This is
normal for the initial heat-up of the
tank.
Turn Temperature Control to lower
temperature setting if you notice
vapor or hear boiling noise.
NOTE: Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwise to
lower water temperature.