Troubleshooting - Whirlpool GHWT160JXX2 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before calling for service...
If hot water tank does not operate, check these points first:
Has circuit breaker tripped or
house fuse blown?
Is power supply cord plugged
in?
If you need more help, check the chart below. This could save you the cost of a service call for a problem that is
not covered by the warranty.
PROBLEM
Water is not hot.
Vapor appears, tank makes
boiling water noises, or water is
too hot.
Hot water drips or sputters from
faucet.
Water does not flow from
faucet.
Leaking saddle valve.
Water has a "rotten egg" taste.
Part No. 3193352
©2001 Whirlpool Corporation
Is the Temperature Control set
to the "Off" position?
Has the water supply been
turned off?
CHECK THE FOLLOWING
Check that the circuit breaker is not tripped or the house fuse blown.
Check that power supply cord is plugged into electrical outlet.
Check if the electrical outlet is operated by a switch. The switch may
have turned power off.
Cold water in tank is still being heated. Wait 15 minutes and check
temperature again.
Check that the Temperature Control is set to the "Max" setting.
Adjust Temperature Control to a lower setting that eliminates the vapor or
noise. If you live at a high altitude, you may need to lower the thermostat
setting to keep water from boiling.
Check that tubing is not bent or kinked.
Adjust Temperature Control to a lower setting that eliminates the drips or
sputters.
Check for proper installation of copper tubing from faucet to storage tank
and from faucet to cold water line. See "Installation Instructions," Pages 5-6.
Check that water supply valve is open.
If a water filter is used, check that water pressure to hot water tank
is 20 psi (138 kPa) minimum.
Tighten saddle valve clamp screws evenly and firmly. Keep both halves
of bracket parallel. Do Not crush water supply tubing.
Hot water tank is attached to hot water line. Attach to cold water line.
Install a water filtration system on cold water line to tank.
Benton Harbor, Michigan 49022

Troubleshooting

Is the electrical outlet
controlled by a switch?
Printed in U.S.A.

Publicidad

Tabla de contenido
loading

Tabla de contenido