Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: K65001
Wrenches: 7/8"
Drill Bits: 1/2"
1
Qty. (4)
Carriage Bolt, 1/2"-13 x 1-3/4"
2
Qty. (4)
Spacer, 1/4" x 1" x 3"
5
Qty. (2)
Pull Wire
1.
If present remove any plastic rivets from forward attachment on vehicle.
2.
Enlarge forward hole on vehicle with a 1/2 drill bit.
3.
Feed carriage bolts and block thru access point using a pull wire as shown.
4.
Raise hitch into position and fasten as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Ford Econoline
Bumper
Enlarge Hole
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Access Point
For Fasteners
3
Qty. (4)
Conical Toothed Washer, 1/2"
4
Qty. (4)
Nut, 1/2"
Sheet 1 of 3
N65001
Part Numbers:
65001
LB. MAX. WINCH LINE PULL
10-31-05
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 65001
Resumen de contenidos para Cequent Towing Products 65001
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 N65001 10-31-05 Rev. A 2005 Cequent Towing Products...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 N65001 10-31-05 Rev. A 2005 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684. Hoja 3 of 3 N65001 10-31-05 Rev. A 2005 Cequent Towing Products...