Cequent Towing Products 65003 Instrucciones De Instalación

Bumper
Lower
Fascia
Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: 01131-016
Wrenches: 15mm, 16mm, 18mm,
T-30 Torx
Drill Bits: None
1999 Sport Model Fascia
Area to cut
Figure 1
1
Qty. (2) Hex Bolt, M12 x 1.75 x 45 CL10.9
2
Qty. (4) Conical Washer, 1/2"
3
Qty. (2) Spacer, 2" x 1-1/2" x 1/4"
* NOTE: 1999 "Sport Model" vehicles require extensive fascia cut. See Figure 1.
CONSULT VEHICLE OWNER BEFORE TRIMMING.
1. If present, remove lower fascia.
2. Lower sway bar brackets and return fasteners to vehicle owner.
3. If present, remove any fastener in the forward attachment hole on vehicle.
4. Raise receiver into position and reattach sway bar brackets placing the receiver between the frame and the sway bar bracket as shown in
Figure 2.
5. Attach forward fasteners as shown in Figure 2.
NOTE: Bumper brackets may require repositioning to align with receiver mounting holes.
6. If desired, trim lower fascia and reinstall. CONSULT VEHICLE OWNER BEFORE TRIMMING.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
® Driver
Sway Bar
Bracket
Tighten all M10 CL10.9 fasteners with torque wrench to 35 Lb.-Ft (47 N-m).
Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Dodge Ram*
CARGO CAPACITY – DO NOT EXCEED
Existing Weldnut
4
Qty. (2) Nut, M12 x 1.75
5
Qty. (4) Hex Bolt, M10 x 1.5 x 35 CL10.9
6
Qty. (4) Conical Washer, 3/8"
Sheet 1 of 3
Part Numbers:
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL
9000
Recovery Eye
Figure 2
N65003 11-07-05
65003
Rev. A