Cleaning And Maintenance - IKEA MATÄLSKARE Manual De Instrucciones

ENGLISH

Cleaning and maintenance

CLEANING
WARNING!
- Never use steam cleaning equipment.
- Only clean the oven when it is cool to the touch.
- Disconnect the appliance from the power supply.
- Oven exterior
IMPORTANT: do not use corrosive or abrasive detergents.
If any of these products accidentally comes into contact with the
appliance, clean immediately with a damp cloth.
• Clean the surfaces with a damp cloth. If it is very dirty, add a few drops
of washing up detergent to the water. Finish off with a dry cloth.
Oven interior
IMPORTANT: do not use abrasive sponges or metallic
scrapers or scourers. Over time, these can ruin enamelled surfaces
and the oven door glass.
• After every use, allow the oven to cool then clean it preferably
while it is still warm in order to remove built-up dirt and stains
caused by food residues (e.g. food with a high sugar content).
• Use proper oven detergents and follow the manufacturer's
instructions to the letter.
• Clean the door glass with a suitable liquid detergent.
The oven door can be removed to facilitate cleaning (see
MAINTENANCE). Inner glass is smooth to facilitate cleaning.
Accessories
Soak the accessories in water with washing up detergent
immediately after use, handling them with oven gloves if still hot.
Food residues can be easily removed using a brush or sponge.
MAINTENANCE
WARNING!
- Use safety gloves.
- Ensure the oven is cold before carrying out the following operations.
- Disconnect the oven from the power supply.
To remove the shelf guides
firmly grip the external part of the guide, and pull it towards
you to extract the support and the two internal pins from the
lodging.
To reposition the shelf guides
position them near the cavity and initially insert the two pins
into their lodgings. Next, position the external part near
its lodging, insert the support, and firmly press towards the wall
of the cavity to make sure the shelf guide is properly secured.
To remove the door
1. Open the door fully.
2. Lift the catches and push them forwards as far as they will
go (Fig. 1).
Fig. 1
3. Close the door as far as it will go (A), lift it up (B) and turn it
(C) until it is released (D) (Fig. 2, 3, 4).
Fig. 2
To refit the door
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door
Cleaning the glass
1. After removing the door and resting it on a soft surface
with the handle downwards, simultaneously press the two
retaining clips and remove the upper edge of the door by
pulling it towards you.
2. Lift and firmly hold the inner glass with both hands, remove
it and place it on a soft surface before cleaning it.
3. To reposition the internal glass properly, be sure that the "R"
can be seen in the left corner.
First insert the long side of the glass indicated by "R" into the
support seats, then lower it into position.
4. Refit the upper edge: A click will indicate correct positioning.
Make sure the seal is secure before refitting the door.
To replace the lamp
5. Disconnect the oven from the power supply.
6. Unscrew the lamp cover (Fig. 5), replace the lamp (see note
for lamp type) and screw the lamp cover back on.
7. Reconnect the oven to the power supply.
NOTE:
Only use 25W/230 V type G9, T300°C halogen lamps.
The lamp used in the appliance is specifically designed for
electrical appliances and it is not suitable for household room
illumination (Commission Regulation (EC) No 244/2009).
Lamps are available from IKEA Authorized Service Centre.
This product contains a light source of energy efficiency class G.
Cable
Power cable replacement (type H05 RR-F 3 x 1,5 mm2) must be
carried out by a qualified electrician. Contact IKEA Authorized
Service Centre.
7
Fig. 3
Fig. 4
Fig. 5