S&P IFAB Manual Del Usuario página 6

ENGLISH
IFAB – Induction Jetfan for Ventilation with AC motor Single Phase
IFEB – Induction Jetfan for Ventilation with EC motor Single Phase
1. INTRODUCTION
Thank you for purchasing this appliance. It has been manufactured in full compliance with applicable safety regulations and EU
standards. Please read this instruction book carefully, as it contains important information for your safety during the installation,
use and maintenance of this product. Keep it to hand for future reference. Please check that the appliance is in perfect condition
when you unpack it, as all factory defects are covered by the S&P guarantee.
2. SAFETY REGULATIONS AND "CE" MARKING
S&P technicians are firmly committed to research and development of ever more efficient products and in compliance with current
safety regulations. The instructions and recommendations given below reflect current regulations, principally regarding safety,
and therefore are based on compliance with general regulations. Therefore, we recommend all people exposed to hazards to
strictly follow the safety regulations in force in your country. S&P will not be held liable for any possible harm or damage caused
by non-compliance with the safety regulations, as well as caused by modifying the product. The CE mark and the corresponding
declaration of conformity are proof of the product's conformity with current EU regulations.
3. GENERAL INSTRUCTIONS
A hazard analysis of the product has been carried out as provided in the Machine Directive. This manual contains information for
all personnel exposed to these hazards, with the aim of preventing possible harm or damage due to faulty handling or maintenan-
ce. All maintenance operations (ordinary and extraordinary) must be carried out with the machine switched off and the electrical
power supply disconnected. To avoid a possible accidental start up, place a warning notice on the electrical control panel with the
following text:
"Attention: control disconnected for maintenance operations"
Before connecting the power supply cable to the terminals, make sure the mains voltage corresponds to the voltage indicated on
the specification plate of the unit. Regularly check the product labels. If, due to the passing of time, they are no longer legible, they
must be replaced.
4. UNIT LABELLING
The machine may come with several pictograms that must not be removed.
These signs are divided into:
• Prohibition signs: Do not repair or adjust when in operation.
• Danger signs: Warning of the presence of live elements inside the container bearing the sign.
• Identification signs: CE card, indicating product information and manufacturer's address. The CE mark indicates the product's
conformity with EEC standards.
Danger signs Prohibition signs
5. HANDLING
This range of cased centrifugal JetFans may be individually packaged, or palletized in larger quantities. In all cases the lifting will
be from the base.
Has been manufactured to the rigorous standards of protection and quality control in accordance with the International Quality
Standards ISO 9001. All components have been checked and tested at the end of the manufacturing process.
6. INTENDED USE
These JetFans are designed for installation in car parking / garage / storage applications to induce air movement from air inlet
points to air outlet / extraction points, and should be installed in accordance with all National and Local standards applicable.
6