Horizon Global 36635 Instrucciones De Instalación página 4

Remove Excess Caulk- Remove excess caulk from the frame rails in
the hitch installation area.
Enlarge access hole – Using a die grinder or other suitable tool, enlarge
the access hole enough for the carriage bolt head to fit through. See
figure 2
Install hitch - Raise hitch into position. Feed the end of the fish wires
through the attachment holes in the hitch, be careful not to push the
hardware back into the vehicle frame. Loosely install items 3 and 4 to
hold the hitch in place. Conical washer teeth side against hitch.
©2017 Horizon Global™ Corp. - Printed in Mexico
Install hardware - Using the fish wire install items 1 and 2 as shown in
figure 1 through the access hole in the vehicle frame. Repeat for both
sides. Note: Keep the fish wire attached to the hardware.
Torque fasteners - Tighten all ½-13 GR5" fasteners with torque wrench to
75Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when
.
towing
Sheet 4 of 12 36635NP 8-8-17 Rev. A