Cequent Performance Products 36597 Instrucciones De Instalación página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Always wear SAFETY GLASSES
when installing hitch
Fasteners typical
for both sides
j k
Towhook
o p q
Figure 1
1. Lower exhaust - Remove the rubber isolators from the exhaust at the rear of the vehicle, (figure 2) both sides. It may be necessary to
remove the isolator forward of the rear axle. Spraying a lubricant or soapy water on the metal hanger rod and the rubber isolator eases
removal.
2. Install hardware - Using the fish wire install items 1 and 2 as shown in figure 1 through the large access hole at the end of the vehicle
frame. Repeat for both sides. Note: Keep the fish wire attached to the hardware.
3. Install hitch - Gently raise hitch into position, carefully guiding the hitch over the mufflers. Feed the end of the fish wires through the
attachment holes in the hitch, be careful not to push the hardware back into the vehicle frame. Loosely install items 3 and 4 to hold the
hitch in place. Conical washer teeth side against hitch. Install item 5 over the towhook and through the bracket at the back of the hitch
receiver, then loosely install items 6,7 & 8 onto item 5 as shown in Fig. 1.
4. Tighten all 7/16"-14 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M) and 3/8"-16 fasteners to 30Lb.-Ft. (41 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
5. Raise exhaust – Raise the vehicle exhaust back into position and reinstall all isolators removed in step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 36597, 06183, CQT36597
Frame rail
n
Access hole
Bolt Hole
l m
Fish Wire
Example
m
n
o
Figure 2
p
q
r
Conical Washer
Teeth side
Against hitch
Sheet 3 of 9
36597N
Fastener Kit: 36597F
Qty.(4)
Carr. Bolt
7/16"-14 X 1 1/4" GR5
Qty.(4)
Spacer
3/16" x 1" x 2"
Qty.(4)
Conical washer
7/16''
Qty.(4)
Hex Nut
7/16"-14 GR2
Qty.(1)
U Bolt
3/8''-16 GR5
Qty. (2)
Flat washer
3/8"
Qty. (1)
Lock washer
3/8''
Qty. (1)
Hex Nut
3/8''-16 GR2
Qty. (4)
Fish wire
7/16"
Authorized Drawbar Kit:
36051 (Sold Separately)
Drawbar must be used in the
RISE position only.
1-25-17
Rev. A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

06183Cqt36597

Tabla de contenido