Cequent Performance Products 36593 Instrucciones De Instalación página 4

1. Lower muffler – Lower muffler by removing the (2) rearmost rubber
hangers. Note: A spray a lubricant on rubber hangers makes them slide
off metal pins more easily. NOTE: Be careful that exhaust is supported
before removing rubber hangers.
3. Trim fascia - measure, mark, and trim fascia as shown.
C L
3/4" TYP.
1-1/4"
CENTERLINE OF BUMPER
Bottom View
of Bumper Fascia
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
1" TYP.
2-1/2"
2. Remove underbody appearance panels (if present) – remove (2)
plastic underbody appearance panels, (1) each side, located under the
rear bumper and behind the rear wheels. Using a standard screwdriver,
remove the plastic push rivets from each panel and pull down to remove
the panels from plastic push nuts. Set aside for reinstallation later.
4. Raise hitch into position – raise the hitch over the tailpipe(s) and
align holes in hitch with existing weldnuts in frame rail.
Sheet 4 of 15 36593NP 7-6-16 Rev. B