Safety Precautions
Please take time to read these safety precautions carefully before connecting
your machine to the power supply. It is essential to follow them and the
operating instructions.
– First read this entire operating manual.
– Danger of electric shock! Never immerse the machine in water or any other
liquid.
– Connect only to a properly grounded power point.
– To make sure that the machine is switched off, remove the plug from the
power point.
– Always pull out the power plug before:
* Relocating the machine.
* Cleaning or maintenance.
* Long periods of disuse.
– Never clamp or run the power cable over sharp corners or edges.
– Danger of electric shock! Damaged power cables may only be replaced at the
customer service centre.
– Danger of electric shock! Never touch the power plug/socket/cable or the
machine with damp or wet hands. Never unplug by pulling out the power
cable; always remove the plug.
– If you need an extension cable, make sure it is suitable for your machine
(3-pole grounded, 1.5 mm2 conductor cross-section), and lay the cable to
avoid tripping.
– Danger of scalding! Never move the machine during operation!
– Do not use the machine in case of:
* Faulty operation.
* Damaged power cable.
* After falling or other damage.
* In such cases immediately have the machine checked and repaired if
necessary at the customer service centre.
– The machine location must meet the following requirements:
* Choose a dry, stable and level support surface not immediately underneath
the power point. at least 60 cm away from the washbasin and taps.
* Never place on flammable/fusible surfaces or equipment.
* Never place the machine or power cable on or nearer than 50 cm to hot
surfaces or open flames.
* Never cover the machine during operation.
– Keep children away from the machine during operation.
EN_3