MODO CAF-0161 Manual De Instrucciones página 7

Before using for the first time or after long pauses (e.g. holidays) the machine
must be flushed out. This short procedure can flush out and cleans the internal
piping thoroughly.
There are two ways to fill the water tank: directly into the machine, by using
for example a jug, or by removing the water tank.
1
Filling without removing the tank
– raise the water tank cover
– Fill the tank with cold fresh water
– the maximum capacity is 0.6 litre
– low down the tank cover
2
Filling by removing the water tank
– Hold the water grip at tilting angle as shown in
direction to remove the water tank from the
machine.
- Fill the tank up to Fill the tank up to the "MAX"
mark with cold fresh water (the maximum
capacity is 0.6 litre).
– Slide the water tank slowly on water tank base,
when the water tank outlet is inserted in the inlet
receptacle, pushing firmly on the water grip as
shown in direction to lock the water tank .
3
Connect the power supply
5
Press the lungo coffee button, wait for the appliance to complete the flush out.
– Before pressing the button, make sure that:
– the handle is closed without capsule inside.
– the water tank is full.
– the water tank is firmly in place, otherwise water may
leak
– a large bowl ( 250ml size or above) is placed under the
dispenser.
press the lungo coffee button to start flush out.
– Open the handle when the flush out process stopped
automatically.
– Empty the cup.
– Flush out cycle is finished.
4
Press the s
witch button
EN_7
The lights at buttons
become steady when the
machine is heated up
heating up time is 45
seconds approximately