Assembly Instructions - CountyLine 579791 Manual Del Propietário

ASSEMBLY INSTRUCTIONS

NOTE: This log splitter was partially assembled at the factory. Refer to the drawings and parts list should it become
necessary to disassemble the unit for repair or replacement of parts. The drawings in this manual are for
reference only. Some of the components on your log splitter may look slightly different.
STEP 1:
Remove all the components from the crate. Inspect each piece for shipping damage. If any part is damaged, contact
your dealer or delivering carrier.
STEP 2:
Install wheel spacer (5) on axle prior to attaching wheel. Attach the two wheels (4) to the tank assembly (7) wheel
spindles using the 3/4" light flat washers (3), 3/4" NF slotted nuts (2), 1/8" x 1-1/2" cotter pins (6) and the hub caps
(1). These items are in the hardware package. Tighten the slotted nuts and make sure the wheels rotate freely.
ITEM DESCRIPTION
1 HUB CAP
2 3/4 IN-16 SL-NF HEX NUT
3 3/4 FLAT WASHER
4 WHEEL
5 SPACER
6 1/8 X 1-1/2 IN COTTER PIN
7 TANK ASSEMBLY
ITEM 28T DESCRIPTION
1 TONGUE ASSEMBLY
2 WHEEL
3 TANK ASSEMBLY
4 BEAM ASSEMBLY
QTY
2
2
2
2
2
2
1
Page 5
M8437
35T DESCRIPTION
TONGUE ASSEMBLY
WHEEL
TANK ASSEMBLY
BEAM ASSEMBLY
QTY
1
2
1
1
M8438