CountyLine 579791 Manual Del Propietário página 9

STEP 3:
Attach the tongue assembly (1) to the tank assembly (2) using four 3/8"NC x 1.0" hex cap bolts (3), Tighten. Install manual
tube (5) using 5/16" NC X .75" screws (4).
STEP 4:
Make sure the rear stand is deployed with lock pin in place. Stand the beam (2) up on end. Two people may be
needed for this step to ensure safety. Make sure that the beam is stable and on a level surface. Install the bushing (5)
and spacer (6) in slot toward rear of tongue. Roll the tongue/ tank assembly (1) into position between the two tabs on
the beam. Install 1/2" screw (4) though beam pivot and spacers. Install 1/2" nut (3). Tighten nut to remove excess play
but still allow beam to pivot and slide. Install debris shield (10) with debris shield bracket (11) and hose guide channel
(12) using nut (7) and screw (8).
ITEM
1
2
3
4
5
6
7
8
9
10
11
12
ITEM DESCRIPTION
1 TONGUE ASSEMBLY
2 TANK ASSEMBLY
3 HFS 3/8 NC X 1.0, PATCH GR5 SCREW
4 HFS 5/16 NC X .75 GR5 SCREW
5 MANUAL TUBE
DESCRIPTION
TONGUE ASSEMBLY
BEAM ASSEMBLY
HFN 1/2 NC FLANGE LOCK NUT
HFS 1/2 NC X 4.0 GR5 SCREW
BUSHING, EWZ
SPACER, EWZ
HFN 5/16 NC FLANGE LOCK NUT,
SCREW, CB 5/16 NC x .75 SCREW
HFN 5/16 NC x 1.0 GR5 SCREW,
DEBRIS SHIELD
DEBRIS SHIELD BRACKET
HOSE GUIDE CHANNEL
QTY
1
1
4
2
1
QTY
1
1
1
1
1
1
6
2
4
1
2
1
Page 6
M8439