Publicidad
Idiomas disponibles
Idiomas disponibles
1-2
QLogic QLA2100 Host Bus Adapter Card Installation Guide
All manuals and user guides at all-guides.com
Insert the QLogic drivers and firmware update diskette into the system’s diskette
6.
drive.
7 .
Type D ?QW as the path to the driver and then click OK.
8.
Select QLogic QLA2000/QLA2100 PCI-Fibre Channel Adapter from the list of
drivers and click OK.
9.
When the following message appears, click OK to exit the Control Panel:
7KHFKDQJHV\RXKDYHPDGHZLOOQRWWDNHHIIHFWXQWLOWKH
FRPSXWHULVUHVWDUWHG
10. Click OK to reboot your system.
8SGDWLQJWKH4/RJLF4/$%,26
Your host adapter card is configured with the current version of the basic input-output
system (BIOS). If you need to update the card’s BIOS, perform the following steps:
1.
Insert the QLogic drivers and firmware update diskette into the system’s diskette
drive and boot your system.
2.
When the D ? prompt appears, type FGELRV and press <Enter>.
3.
Type TO[XWLO and press <Enter>.
A list appears showing the addresses of the host bus adapters installed in the
system.
4.
Type the correct adapter address and press <Enter>.
5.
Press <F> and then press <Enter> to flash the BIOS.
When the BIOS upgrade is successfully completed, the following message
appears:
)ODVKSURJUDPPHGVXFFHVVIXOO\
6.
Repeat steps 3, 4, and 5 for any other host bus adapters installed in the system.
7 .
After you finish updating the BIOS for all host bus adapter cards in the system,
you must turn off and then turn on the system for the changes to take effect.
Publicidad
