Parts And Functions - Haier AS07QS1ERA Manual De Operación

Parts and Functions

Indoor Unit
Inlet
Inlet grille
Outlet
Nano-aqua
Horizontal flap
generator
(Adjust up and
(inside)
down air flow,
Don't adjust
it manually)
Actual indoop unit may vary from the one shown
in the manual, according to the product purchased.
Display board
Aureol
Display mode，the aureole display different
colour when setting different function
COOL: blue HEAT: red
AUTO: white DRY: cyan
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
(inside)
Emergency
Switch
Display board
Vertical blade
(Adjust left and
right air flow)
TEMP display
FAN: yellow
: green
HEALTH
4
Remote controller
1
6
2
7
3
4
5
8
9
18
10
19
11
20
12
21
13
22
14
23
15
24
16
25
17
1. Mode display
Operation mode
AUTO COOL DRY HEAT FAN
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
LO MED HI AUTO
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
Healthy function is not available for some units.
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or wireless telephone is installed in the
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
8. Additional functions display
Operation mode QUITE SLEEP HEALTH
Remote controller
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN SPEED button
14. TIMER button
15. HEALTH button
16. LOCK button
Used to lock buttons and LCD display.
17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
22. HOUR button
23. EXTRA FUNCTION button
Function: FAN mode --- Healthy
airflow position1--- Healthy airflow
position 2 --- Restore the original
flap position --- Right & left air airflow
--- A-B yard---10 and heating symbol
displayed simultaneously--- Sleeping
--- Electrical heating--- Refresh air
( --- Power ---
reserved function)
Fahrenheit/Celsius mode conversion
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this button
to reset the remote
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
e" + "/"-";
is in line with th
POWER
1