Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
5. Advanced learning modes, these modes need a hardware switch setting on the module
Sometimes it can be necessary to have more advanced actions like starting a timer to turn on the light for 10 min.
For that, more advanced modes can be learned including short press and long press actions. Combinations can be made.
ADDR. SWITCH SETTING
Ch.1
Ch.2
Ch.3
C1
C2
C3
B1
B2
B3
A1
A2
A3
91
92
93
81
82
83
EXAMPLE:
Button(s) must start output relay number 2 for 10 minutes, push again to stop the timer.
Turn the switches in position "B 2" (mode LED 2 will blink fast, indicating learning is activated)
Press one by one the push buttons (for at least 2 sec) that need to activate this output .
To confirm the corresponding output 2 will be activated.
RETURN THE MODULE TO ITS DEDICATED ADDRESS TO EXIT THE LEARNING
MODE.
Now for this example, rotate the timer rotary switch of output 2 to position 8 (10 min timer, see time 1 table)
☺
If other timer is wanted, simply turn to other time setting.
6
Operation mode description (see also table on next page)
Ch.4
[PBM] Button(s) activating the "operation mode" 0 to F and using a timer from TIME 1
C4
table switches, a long press will activate a timer from the TIME 2 switch settings.
[TG1] Button(s) starting or stopping a timer from TIME 1 table switches: 1 to F
B4
A4
[TG2] Button(s) starting or stopping a timer from TIME 2 table switches: 7 to F
94
[ST1] Button(s) starting or restarting a timer from TIME 1 table switches: 1 to E
[ST2] Button(s) starting or restarting a timer from TIME 2 table switches: 7 to E
84
Ou t1
Out2
Out3
Ou t4
ADDR.
CH1
CH 2
CH3
C H4
ON
Rx
Tx
Mode1
Mo de2
Mod e3
Mode4
Publicidad
