Yedoo YOOTOO Manual Del Usario página 4

Assembly Instructions
1. 2.
2
10 Nm
1
Seat installation
Before assembly, remove the plastic
covers from the front and rear wheel
Put the seat tube into the frame (1) of
axis.
the balance bike, adjust the desired
Handlebar installation height (do not exceed the maximum
mark) and tighten the sleeve screw (2).
Place the handlebar into the main frame
tube (1) of the balance bike, adjust the
desired height and tighten the screw on
the stem (2).
3.b 4.
1
10 Nm
2
10 Nm
Place the wheel into the front fork so Adjustment of brake levers
that is well-centered and tighten the
Incline the brake levers correctly by
nuts (1, 2). (For easier installation you can
loosening the screw on the sleeve (1).
turn the balance bike upside down).
The right inclination:
If the tire has an arrow-shaped tread
pattern, the arrows should be pointing
Let the child sit on the balance bike,
to the front.
hold the handles and stretch out your
fingers in a way that his/her arm and
the fingers form a single straight line.
This should be the position of the brake
lever.
EN
3.a
1
Max
2
2
6 Nm
Front wheel installation
Make sure the front fork of the balance
bike is well positioned (the bending of
the fork faces forward).
5.a
1
1
1
5 Nm
Adjustment of brake
Before adjusting the brakes, inflate
the tires according to the values on their
side (ideally between 1,3 and 1,8 bars).
Check that the brake pads fit tightly
on the rim sides. Their position can be
adjusted via the screws (1). The pads
shall not touch the tires.
5.b
Check that the pads make enough
space (1–2 mm) after releasing the brake
levers. The distance can be adjusted by
tightening or loosening the brake cable
at the anchor screw (2).
6.
1
Protective pad installation
Place the soft protective pad from
washable nylon over the handlebar stem.
6 7
5.c
2
3 3
In case the brake pad is touching
the wheel when turning, symmetrically
adjust the distance of brake arms by
the tightening screws (3).
7.a
YooToo
7.b
YooToo
5.d
Fasten the end of the brake cable in
the lock and secure with the cable tie,
then trim the tie.
YooToo
Yedoo YooToo is equipped with double
dropout at the rear fork, which enables
a bigger range of seat height. The upper
dropout is meant for lower seat position.
The lower dropout, on the contrary,
enables the seat to be positioned higher
than usual. Warning: after each position
change, readjust the brakes.
EN