Installation Steps; Care And Cleaning - LUND Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Insert visor into window channel,
rear flange first. Rear flange inserts
between the trim and the exterior
suraface. The front & top flange
slides into the window channel.
3
Apply pressure to all flange edges to ensure proper
adhesion.
5
4 Piece Set
Install the rear visor using the same preparation and installation methods as front visor. Note
that the top & rear flanges slide into the window channel, and the front flange fits between the
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 7 for remaining visors
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2015 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Remove tape liner by pulling on free ends. Raise
window slowly and leave up for 24 hours to secure
visor to window channel.
4
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
6
rubber & window frame.
Page 2 of 2