Leggett & Platt PRO-MOTION perfomance Queen Manual Del Usario página 11

STEP 10
Install headboard brackets to the base frame as follows:
a. Raise the head section of the base (with remote control) to gain access
to the base frame.
b. Locate channel connector kit (FIGURE 4). On one side of base frame,
locate (2) holes for channel connector mounting (FIGURE 5).
c. Position channel connector so that the flat side is flush against base
frame. Attach channel connector to base frame using (2) 1½ inch long
hex head bolts/nuts (FIGURE 5). Tighten bolts. Note: For units with
74" base length, use inner mounting holes. For units with 80" base
length, use outer mounting holes (FIGURES 4 and 5).
FIGURE 4
74" BASE
LENGTH
80" BASE
MOUNTING
LENGTH
HOLES
MOUNTING
HOLES
FIGURE 5
(2) 1-1/2 INCH LONG
HEX HEAD BOLTS/NUTS
INSTALLATION
74" BASE
LENGTH
MOUNTING
HOLES
Performance Models Pro-motion Owners Manual 99301466-b
11