Tripp-Lite U339-002 Manual Del Propietário página 4

Docking Station Installation
Note: If your SATA hard drive has not been formatted
yet, you will need to format it using your computer's
Disk Management utility in order to access it.
1. Connect the included power supply to
the unit and plug it into a Tripp Lite Surge
Protector, Power Distribution Unit (PDU), or
Uninterruptible Power Supply (UPS).
2. Insert your 2.5" or 3.5" SATA Hard Drive
into an available bay on the docking station,
making sure it is securely seated on the
SATA connector. Repeat this step to connect
an additional hard drive.
3. Connect the included USB 3.0 cable
between your computer and the docking
station.
4. Turn on power to the docking station using
the ON/OFF button on the back of the unit.
The red Power LED will illuminate to indicate
power is being received. The red Drive LEDs
will illuminate to indicate a hard drive is
connected to the corresponding port and
recognized by the computer.
4