Troubleshooting - Harbor Breeze GALILEO E-GAL52BC4GRS Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

Warning: Before beginning work, shut off the power supply to avoid electrical shock.
Problem
Fan does not move.
Noisy operation.
Excessive wobbling.
Fan operates but lights
fail (if applicable).
Note: A small amount of "wobble" is normal and should not be considered a defect.
Possible Cause
1. Power is off or fuse is blown.
2. Faulty wire connection.
3. Plugs and/or antenna wire not
connected properly.
1. Blades (H) are loose.
2. Cracked blade (H).
3. Full range dimmer switch.
4. Fan is new.
1. Blades (H) are loose.
2. Unbalanced blades (H).
3. Fan not securely mounted.
4. Fan too close to vaulted ceiling.
5. Set screw(s) on motor housing
yoke is (are) not tightened properly.
6. Set screw on hanging ball is not
tightened properly.
1. Bulb(s) not installed correctly.
2. Wires in canopy (B) not wired
properly.
3. Wall switch to fan is off.
4. Plugs and/or antenna wire not
connected properly.
5. Light kit is lamped with more
than the allowable 190W, causing
the wattage limiting device to
interrupt the flow of electricity to the light
kit.
11
Corrective Action
1. Turn power on or check fuse.
2. Turn power off. Loosen canopy
(B) and check all connections.
3. Check that male and female plugs
and/or antenna wire in switch housing are
connected properly according to
instructions on page 8.
1. Tighten all blade screws (I).
2. Replace blade (H).
3. Replace with ON/OFF wall switch only.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High speeds.
1. Tighten all blade screws (I).
2. Switch one blade (H) with a
blade (H) from the opposite side.
3. Turn power off. Carefully loosen
canopy (B) and verify that mounting
bracket (C) is secure.
4. Use a longer downrod (A) or move fan
to another location.
5. Tighten yoke set screw(s) securely.
6. Carefully loosen and lower screw on
canopy (B) and verify that set screw on
hanging ball is tightened securely.
1. Re-install bulb(s).
2. Check wires in canopy (B) and, if
necessary, re-wire according to
instructions on page 6 and 7.
3. Make sure that wall switch to fan is on.
4. Check that male and female plugs
and/or antenna wire in switch housing are
connected properly according to
instructions on page 8.
5. Lamp light kit with bulbs that total no
more than 190W.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0131430

Tabla de contenido