Standard Functions; Intercom Calls - Motostar LIVIMN-B Manual Para El Usuario

Buttons lock
Press and hold down button
the buttons will not respond to pressure for 30
seconds to allow for cleaning of the device. If
more than one button is pressed at the same
time or repeatedly by accident, the buttons lock
will be automatically activated for 10 seconds.
The buttons lock is cancelled if there is an
incoming call.

Standard functions

Answering a call
When there is a call, the picture coming in from
the entry panel will be displayed on "MASTER"
devices.
To answer the call, press button
To mute the audio to the entry panel, press
button .
Press button to open the door of the entry
panel displayed.
To end the call, press button
The call will be terminated automatically after
60 seconds.
Note: On some types of system the icon
will light up or a special icon will
appear on the screen to warn that the door
is open.
Self-connection
To see the picture taken by the entry panel
without activating audio communication,
press button . Where there are several
entry panels or video cameras connected to
the system, press button
in succession the pictures taken by these
devices.
To start audio communication with the entry
panel displayed, press button
Activating auxiliary commands
Buttons and can be associated with auxiliary
commands (switching on stair light, opening
gate, etc.).
for 3 seconds;
The buttons are enabled when communication
is active, button
there is no active communication if the system
set-up allows it.
Disabling ring tone
To disable the ring tone, press button
relative LED comes on.
The ring tone will be disabled for all types of
call; therefore, receiving a call from the entry
panel will ONLY activate the video. To reactivate
the ring tone, press button
Video toggle function
In systems with several receivers, when there
.
is a call, the image of the caller is displayed
only on those receivers set up as "MASTER"s.
To display the image of the caller on a "SLAVE"
receiver, press button
communication, press button
.
In systems with several receivers, select the
number of the receiver you want in order to
make the call. Press button
able to select receivers from 5 to 8.
Select the receiver you want; the receiver
calling will give the line-free tone and the
receiver being called will ring.
To answer the call, press button
receiver being called.
Transferring a call
With an active communication, select the
again to show
receiver you wish to transfer the call to (the
receiver that's calling will give the line free
tone, while the receiver being called will ring).
To answer the call, press button
.
receiver being called.
Once audio connection is made with the
can be active even when

Intercom calls

, the
again.
. To enable audio
.
(LED on) to be
on the
on the