Chamberlain MotorLift GWAP120 Manual De Instalación página 22

Now take the wall plug transformer and put it into the designated opening at the bottom of the appli-
ance (see fig.9). Now put the plug into the socket in the wall (see fig.10).
The installation is now complete.
The shutter strap coiler may only be used in connection with the provided wall plug transformer
version 041AGW02.
9
Installation of light sensor GWLS1 (accessory):
A light sensor incl. plug and approx. 1.3m of power cable are separately available.
In order to install the light sensor put the plug of the light sensor in the designated opening with the six
pins at the bottom of the appliance (see fig.11+12). Clean the window pane and position the light sen-
sor onto the window pane as desired. Information: The shutter strap motor will close the shutter after
15min of direct sunlight to the position of the light sensor. In order to open/close shutter again, press
corresponding button on the control panel; this may also be achieved by activated timer control. To
remove or relocate the light sensor only pull on the small plug (fig.13) of the transparent suction cup.
Pulling/Pushing the white plastic top may lead to destruction of light sensor.
11
709156-2GB
10
12
13