Publicidad
Idiomas disponibles
Idiomas disponibles
3. Bumper beam removal - use 14 mm socket to remove (4) factory bolts from bumper beam
and return them to customer. Carefully set the bumper beam aside for reinstallation.
4. Hitch installation – tape (4) flat washers ① on the end panel where the holes locate, see
Figure 1. Tape a spacer block ② on the hitch tab each side, see Figure 2. Raise the hitch
above the exhaust pipe and loosely install M10 bolts ⑤ and 3/8'' conical washers ⑥ to the
upper attachment holes on the end panel. Loosely install M12 bolts ③ and 1/2'' conical
washers ④ to the frame rails. Raise the bumper beam to sandwich the hitch and loosely
secure them by the rest of M10 fasteners at lower attachment holes, see Figure 1.
5. Tighten all M10 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M) and all M12 fasteners to 76 Lb.-Ft. (103 N*M) .
Proper torque is needed to keep the hitch secure to the vehicle when towing.
6. Bumper beam raised bracket height adjustment – use a hammer to bend (3) raised brackets on bumper beam to
reduce the height about 1/4'', see Figure 4a and 4b. Trim the foam piece to fit on the bumper beam, see Figure 4c.
7. Bottom fascia trimming – locate the center of bottom panel and trim 3.0'' tall by 8.5'' wide area, see Figure 5. Trim the
fascia area above the muffler as shown in Figure 6.
8. Reinstall all fasteners, fascia, appearance bottom panel, and mud flaps removed in Step 1, 2.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
8.5''
3.0''
Sheet 6 of 18
76025NP
03-31-17
Rev. A
Publicidad
